Introducing the NEW ACI BACnet™ Sensor Line
Committed to engineering a better sensor solution, ACI has launched the BN Series Temperature and Humidity BACnet™ Sensor Line. This new line has been designed to meet the sensor needs of network-based control systems. ACI’s initial offering includes single point temperature or humidity sensors along with dual point combination temperature and humidity sensors. ACI BACnet™ sensors are available in standard configurations of room/wall, duct, immersion and outside units.
ACI’s single and dual point BACnet™ sensors offer a cost-effective solution for monitoring remote locations and can reduce the need for additional input modules or building management controllers when a limited number of inputs are available.
ACI BACnet™ Sensor Features:
- BACnetTM MS/TP Communication Protocol
- Dip switches to set address and baud rates
- Auto baud rate detection
- Connection “Status” LED
- Temperature unit selection (°F, °C, K) via BACnet™
- Setting of temperature and RH offsets via BACnet™
- Conformally coated PCB (duct, immersion, and outside)
- BTL Certified & Listed
- CE Certified
ROOM – BACnet™ Sensors Series
- The BN Series Room Temperature and Humidity networked sensors are a cost effective, single or dual point native BACnet™ sensing solution designed to reduce the need for additional input modules or building management controllers when a limited number of input points are available.
Click here for more information
DUCT- BACnet™ Sensors Series
- The BACnet Duct Series sensor is designed for use with electronic controllers in commercial heating and cooling building management systems. The ACI BACnet Duct Series sensor can be ordered to monitor temperature, RH, or temp/RH in commercial HVAC ductwork. It uses BACnet MS/TP for physical connection to a BAS or controller, has dip switches to set addresses and baud rate, and has on board end-of-line termination. There is no analog output.
Click here for more information
OUTSIDE AIR- BACnet™ Sensors Series
- The BN Series Outdoor Temperature and RH networked sensors are a cost effective, single or dual point native BACnet™ sensing solution designed to reduce the need for additional input modules or building management controllers when a limited number of input points are available. These sensors incorporate a conformally coated printed circuit board inside of a UV protected weather proof enclosure with easy access to the wiring and internal dip switches using the twist on cover.
Click here for more information
IMMERSION- BACnet™ Duct Sensor
- The BN Series Duct and Immersion networked temperature sensors are a cost effective, single point native BACnet™ sensing solution designed to reduce the need for additional input modules or building management controllers when a limited number of input points are available. The BTL Certification provides confidence that these sensors may be used in any new or retrofit installation using a BACnet™ MS/TP controller with third party BACnet™ devices.
Click here for more information
0 Comments Leave a comment